|
CPH - Circular Power Head
The "Circular Power Head" is a 360 degree ring in two half pieces.
It is wrapped around columns with nearly any diameter and enable the Aqua Cutter HVD/HVE to work a column all around without moving the robot.
The roller will travel a preset distance to one side of the pillar and returnes to the other side by the robot control system.
When the required depth is reached, the CPH will move either upwards or downwards depending on the pre-set direction of travel.
The CPH is attached to the Aqua Cutter with its centre displaced from that of the turn plate.
This allows the CPH to reach the top of the pillars before the tower hoist reaches the underside of the bridge or the ceiling of an enclosure, such as a parking garage or factory.
When the CPH is rotated 180° it is possible to cut below grade.
The offset distance can be extended for deeper below grade requirements.
| Technical data |
| Pillar diameter |
700-1200 mm (larger on request) |
| Fits to robots |
All HVD / HVE models |
| Working angle |
360° around the pillar |
| Oscillation |
Yes |
| Lance attach angle |
Pre set |
|
;)
;)